Plumbing Services Alpharetta, GA

We responded to our customer in Alpharetta, GA to complete a Rheem tankless water heater installation as part of the Rheem Field Trial program. As part of this manufacturer field trial, we installed a new Rheem tankless water heater along with a new service valve kit, which allows for easier access when performing routine tankless water heater maintenance, flushing, and descaling. We completed the necessary plumbing connections to properly connect the new unit to the home's hot water system. After completing the installation, we restored the water supply and tested the new Rheem tankless water heater to verify proper operation and confirmed all plumbing connections were leak free.

We responded to our commercial customer in Alpharetta, GA to complete several plumbing repairs and fixture upgrades throughout the property. The customer requested the installation of a new TOTO bidet toilet seat and an upgrade to an existing outdoor faucet (hose bibb). We installed the new TOTO bidet seat and replaced the existing hose bibb with a new outdoor faucet. We also addressed a leaking drain trap underneath a sink by removing the existing trap and installing a new one to prevent further water leakage. After completing the installations and repairs, we restored the water supply and tested the new fixtures, outdoor faucet, and sink drain connections to verify proper operation and confirmed everything was leak free.

We responded to our customer in Alpharetta, GA after they experienced water temperature issues in their master bathroom shower, where only hot water was coming through the showerhead. Upon inspection, we found that the shower valve's temperature limit setting was incorrectly adjusted and that debris had accumulated on the shower cartridge, affecting the shower's temperature control. We corrected the temperature limit setting to allow the proper mixing of hot and cold water. After making the adjustment, we turned the water back on and tested the master shower to verify proper hot, cold, and warm water flow. We confirmed the shower was operating properly and the water temperature could be adjusted as intended.

We responded to our customer in Alpharetta, GA after they experienced a loss of hot water and reduced water pressure at their master bathroom tub and shower. Upon inspection, we determined that debris inside the shower valve was restricting water flow. We shut off the hot water supply and disassembled the hot side valve stem to access the internal components. We then flushed the valve using both the cold and hot water supplies to remove accumulated debris and restore proper water flow. After thoroughly flushing the shower valve, we reassembled the components, restored the water supply, and tested the tub and shower to verify proper hot water flow and water pressure. We also inspected the plumbing connections and confirmed everything was operating properly and leak free.

We responded to our customer in Alpharetta, GA to complete a Rheem Field Trial tankless water heater replacement. As part of the Rheem Field Trial program, we removed the existing tankless water heater and installed a new Rheem tankless water heater in its place. After completing the installation and necessary plumbing and utility connections, we restored the water and tested the new tankless water heater to verify proper operation and confirmed all connections were leak free.

We responded to our commercial customer in Alpharetta, GA after they reported that a newly installed toilet in the powder room had continued running since installation. Upon arrival, the toilet was not running, so we checked the water pressure and found it at approximately 60 PSI. We flushed the toilet multiple times to determine whether the canister was sticking and confirmed the fill valve was turning on and shutting off properly. We also removed and inspected the canister and seal and found no visible defects or issues at the time of our visit. We were unable to recreate the running condition during testing. If the issue occurs again, we can replace the fill valve and canister seal in case there is an intermittent defect that could not be seen or duplicated during our evaluation.

We responded to our customer in Alpharetta, GA due to an issue with the hot side of their bathtub valve. We rebuilt the hot side of the bathtub valve and reinstalled the existing stem to restore proper operation. After completing the repair, we restored the water supply and tested the bathtub valve and plumbing connections to verify proper operation and confirmed everything was leak free.

We returned to our customer in Alpharetta, GA to continue an ongoing bathroom remodel and complete the plumbing trim out portion of the project. During this visit, we installed four new Delta 8 inch widespread lavatory faucets. We also installed eleven new emergency shutoff valves with escutcheons for the bathroom plumbing fixtures. After completing the installations, we restored the water supply and tested the new faucets, shutoff valves, and plumbing connections to verify proper operation and confirmed everything was leak free.

We returned to our commercial customer in Alpharetta, GA to continue work on an ongoing laundry remodel project. During this phase of the remodel, we installed a new wall mounted ceramic laundry/utility sink along with a new faucet and completed the necessary plumbing connections. After completing the installation, we restored the water supply and tested the new sink, faucet, drain, and plumbing connections to verify proper operation and confirmed everything was leak free.

We responded to our commercial customer, a preschool in Roswell, GA, after they reported a toilet leaking in the art room. During our evaluation, we found the toilet was leaking from the spud connection when flushed and that the spud was also moving out of position. We repaired the Sloan flush valve assembly by replacing the spud, spud seals and connection, along with the vacuum breaker. After completing the repairs, we tested the toilet through multiple flushes to verify proper operation and confirmed the Sloan valve and plumbing connections were leak free.

We responded to our customer in Alpharetta, GA after glasses and a coat hanger accidentally became lodged in the toilet and needed to be removed. We removed the objects from the toilet to restore proper flushing and drainage. While onsite, we also replaced the toilet’s emergency shutoff valve and replaced the Studor air admittance valve (AAV) underneath the master bathroom lavatory sink. After completing the repairs, we tested the toilet, sink, and plumbing connections to verify proper operation and confirmed everything was leak free.

We returned to our customer in Alpharetta, GA to continue an ongoing bathroom remodel and complete the plumbing trim out portion of the project. During this visit, we installed a new Kohler toilet, bathtub waste and overflow, tub and shower trim, and shower head. We also extended two water lines as needed to accommodate the new bathroom layout and fixtures. After completing the trim out installations, we restored the water supply and tested the toilet, tub and shower fixtures, drains, and plumbing connections to verify proper operation and confirmed everything was leak free.

We returned to our commercial customer in Alpharetta, GA to begin the bathroom rough in plumbing for their project. As part of the rough plumbing work, we replaced the tub and shower valve and modified and extended the water supply lines to accommodate the new lavatory locations. We also extended the lavatory drain lines as needed for the new bathroom layout. After completing this phase of the bathroom plumbing rough in, we turned the water back on and tested the new water lines, valve, and plumbing connections to verify proper operation and confirmed everything was leak free.

We responded to our customer in Alpharetta, GA after they noticed water coming up from the ground in their front yard, indicating a possible underground water line leak. During our inspection, we excavated the affected area and located the damaged section of the underground water line. We removed the leaking section and replaced it with new PEX piping to restore the integrity of the water service line. After completing the repair, we restored the water supply and thoroughly tested the repaired water line to verify proper operation and confirmed it was leak free.

We responded to our customer in Alpharetta, GA after they reported an overflowing pump and a continuously running toilet. During our inspection, we disassembled the pump basin to evaluate the pump and found the weep hole was clogged, causing the pump to become air locked and preventing it from operating properly. We cleared the obstruction, restored proper pump function, and reassembled the system. After completing the repair, we tested the pump to verify it was operating correctly and confirmed the system was functioning properly and leak free.

We responded to our commercial customer in Marietta, GA to complete the bathroom trim out for their project. We installed a customer supplied wall mounted lavatory faucet trim, a Kohler two piece skirted toilet, and a new emergency shutoff valve with a stainless steel braided supply line. We also supplied and installed a new lavatory drain kit to complete the sink installation. After all fixtures and plumbing connections were installed, we tested the faucet, toilet, drain assembly, and water connections to verify everything was operating properly and confirmed the entire installation was leak free.

We responded to our commercial customer in Marietta, GA to complete a commercial kitchen trim out as part of their project. We installed a customer supplied two hole kitchen faucet with soap dispenser, customer supplied air switch for the garbage disposal, and customer supplied basket strainer. We also supplied and installed an InSinkErator Badger 5 garbage disposal, completed the drain assembly with a Studor vent, and installed emergency shutoff valves with stainless steel braided supply lines where required. After completing the installation, we thoroughly tested the faucet, garbage disposal, drain system, and all water connections to verify everything was operating properly and confirmed the entire installation was leak free.

We responded to our customer in Alpharetta, GA to install the rough in valve for a new wall mounted faucet in the powder room. We carefully installed the valve at the proper depth and location to ensure it would be ready for the finished faucet installation after the wall is completed. Once the rough in installation was finished, we pressure tested the valve and verified all connections were operating properly and free of leaks.

We responded to our commercial customer in Alpharetta, GA to repair a damaged sewer line after a pipe separation was discovered beneath the concrete slab. To access the damaged piping, we removed a section of the concrete slab beneath a built in cabinet and carefully excavated approximately 4 feet to reach the sewer line. We removed the separated section of piping and installed new PVC sewer pipe to restore proper drainage. After completing the repair, we tested the sewer line to verify proper flow and leak free operation. The excavation was then backfilled, and the concrete slab was replaced with a rough concrete finish, leaving the area ready for the next phase of the restoration.

We responded to our commercial customer in Alpharetta, GA after they reported a sewer line blockage affecting one of the units. We used a professional sewer machine to clear the blockage and restore flow through the drain line. Once the line was open, we performed a sewer camera inspection to determine what caused the backup. During the inspection, we located a break in the sewer line that will require repair. We reviewed our findings with the customer and will provide recommendations for correcting the damaged section of sewer piping.

We responded to our customer in Alpharetta, GA to replace a failed sewer ejector pump on a Zoeller Qwik Jon system. The existing pump was no longer operating properly and required replacement to restore normal drainage from the bathroom fixtures connected to the system. We removed the old ejector pump and installed a new replacement pump compatible with the Zoeller Qwik Jon unit. After completing the installation, we tested the system to verify proper pump operation, drainage, and leak free performance. The system is now functioning as intended.

We responded to our customer in Alpharetta, GA after they reported a clogged toilet in the powder room that would not flush properly. Upon inspection, we found a blockage in the toilet drain preventing waste and water from flowing through as intended. We used a hand auger to break up and remove the obstruction without having to remove the toilet. Once the blockage was cleared, we flushed the toilet multiple times and monitored the drainage to ensure the line was flowing properly. The toilet is now flushing normally, draining correctly, and no further issues were found during testing.

We responded to our customer in Alpharetta, GA after they noticed signs of a water leak but were unsure of the source. We ran the bathtub, shower, and flushed the toilet multiple times but found no active leaks. We then filled the bathtub and drained it while monitoring below and still found no signs of water leaking from the tub or drain system. After further investigation, we discovered a crack in the toilet bowl that was allowing water to escape. We initially rebuilt the toilet before identifying the crack in the porcelain. We then replaced the toilet with a new Kohler Cimarron and tested for proper flushing and leak free operation.

We responded to our customer in Alpharetta, GA to complete a kitchen and laundry plumbing remodel. We relocated the kitchen plumbing approximately 3 feet to accommodate the new layout and installed a new ice maker box for the refrigerator water line. We also extended the plumbing for a laundry sink to provide proper water and drain connections. After completing the work, we tested all plumbing connections for proper operation and leak free performance.

We responded to our customer in Alpharetta, GA to address a failing sewage ejector pump. We removed the existing unit and installed a new Liberty sewage pump to restore proper wastewater removal. All connections were properly secured during installation. Once the installation was completed, we tested the system for proper operation and leak free performance.