Plumbing Services Powder Springs GA

We responded to our customer in Powder Springs, GA after they reported issues with the rain shower head in the master bathroom. Upon inspection, we found the cartridge needed to be replaced to restore proper water control and stop leaking. We installed a new cartridge for the rain head and ensured all internal components were seated correctly. We also caulked the trim plate to prevent water from getting behind the wall. After completing the repair, we tested the shower for proper operation and leak free performance. The rain shower is now functioning properly with no leaks.

We responded to our customer in Powder Springs, GA after they reported a shower drain stoppage. Upon arrival, we cleared the clogged shower drain to restore proper water flow. Once the blockage was removed, we ran water to test the drain and confirmed it was draining normally. The shower is now functioning properly with no standing water.

We responded to our customer in Powder Springs, GA to perform a sewer line inspection due to ongoing drainage concerns. Using a sewer camera, we inspected the line and located two problem areas causing issues with proper flow. Based on the findings, the sewer line will need to be excavated and repaired to correct the damaged sections. We discussed the results with the customer and will provide repair options to resolve the issue and restore proper sewer function.

We responded to our customer after they reported a leaking thermal expansion tank near their water heater. A failing expansion tank can cause constant dripping and lead to high water pressure and water heater damage if not addressed. Upon inspection, we confirmed the thermal expansion tank was leaking continuously and no longer functioning properly. To resolve this issue, we removed the failed expansion tank and installed a new replacement. After installation, we turned the water back on and checked the system for leaks ad proper pressure control. Everything tested leak free and and is now operating as designed.

We responded to our customers home after they reported a water leak in the ceiling, with a jet tub located above the affected area. Upon arrival, we noted there was already an opening in the sheetrock below the hallway bathtub, which allowed access for inspection. We removed the access panel and found that the overflow pipe on the tub was not connected, allowing water to leak whenever the tub was filled or used. The slip nut was present but had not been secured properly. We reconnected the overflow pipe using the existing slip nut and ensured the connection was tight and properly aligned. Once secured, we tested the tub to confirm the leak was resolved. After verifying proper operation, we reinstalled the access panel.

We responded to our customers home to replace a leaking hose bibb and its shutoff valve located at the back of the house. Upon inspection, we found the existing hose bibb was worn and actively leaking, and the interior shutoff valve was no longer holding properly. To prevent further water loss and potential damage, we shut off the water supply and removed the old components. We installed a new, high quality hose bibb along with a new shut off valve to ensure reliable operation. After installation was complete, we restored water pressure to the home. We thoroughly tested both the hose bibb and the shut off valve to confirm proper operation and verify there were no leaks. The outdoor water connection is now functioning properly and securely.

We responded to our customer after they noticed a possible water leak near the exterior meter. Upon arrival, we inspected the area and traced the leak to a spot approximately two feet from the meter box. We dug up the section of yard to expose the damaged portion of the water line. Once the pipe was fully uncovered, we cut out the compromised section and made the necessary repairs to restore proper flow. After completing the repair, we turned the water back on and tested the line for leak free operation. We also checked the surrounding soil to ensure no additional moisture was present. The water service is now fully restored and operating as intended.

We were called out to replace our customers toilet that has a crack in the porcelain, which was causing a slow leak around the base. We removed the old toilet and inspected the flange and drain connection to ensure they were in good condition for the new installation. We installed a new wax ring seal then set and secured a new Kohler Cimarron toilet in its place. After reconnecting the water supply line, we turned the water back on and tested for leak free operation.

We responded to our customer to investigate a water leak that was showing up as standing water in the yard beside the driveway. Once on site, we began digging and tracing the water line to locate the source of the leak. After exposing the accessible portions of the pipe, we confirmed that the leak was not in the open yard area as originally suspected. Instead, the water line is leaking underneath the driveway slab, causing water to surface in the nearby yard. We discussed this with our customer and explained the repair options for addressing a leak beneath concrete. We provided our customer with an estimate for the necessary work, and we will return to complete the repair once approval is received.

We were called out after our customer discovered a leak coming from a compression tee fitting on the water line. Upon arrival, after inspecting the area, we confirmed that the fitting had failed and was allowing water to escape around the connection. We removed the leaking compression tee and replaced it with new copper fittings and pipe. Once the repair was complete, we restored water pressure and tested the line for leaks.