Plumbing Services Alpharetta, GA

We responded to our customer in Alpharetta, GA to install the rough in valve for a new wall mounted faucet in the powder room. We carefully installed the valve at the proper depth and location to ensure it would be ready for the finished faucet installation after the wall is completed. Once the rough in installation was finished, we pressure tested the valve and verified all connections were operating properly and free of leaks.

We responded to our commercial customer in Alpharetta, GA to repair a damaged sewer line after a pipe separation was discovered beneath the concrete slab. To access the damaged piping, we removed a section of the concrete slab beneath a built in cabinet and carefully excavated approximately 4 feet to reach the sewer line. We removed the separated section of piping and installed new PVC sewer pipe to restore proper drainage. After completing the repair, we tested the sewer line to verify proper flow and leak free operation. The excavation was then backfilled, and the concrete slab was replaced with a rough concrete finish, leaving the area ready for the next phase of the restoration.

We responded to our commercial customer in Alpharetta, GA after they reported a sewer line blockage affecting one of the units. We used a professional sewer machine to clear the blockage and restore flow through the drain line. Once the line was open, we performed a sewer camera inspection to determine what caused the backup. During the inspection, we located a break in the sewer line that will require repair. We reviewed our findings with the customer and will provide recommendations for correcting the damaged section of sewer piping.

We responded to our customer in Alpharetta, GA to replace a failed sewer ejector pump on a Zoeller Qwik Jon system. The existing pump was no longer operating properly and required replacement to restore normal drainage from the bathroom fixtures connected to the system. We removed the old ejector pump and installed a new replacement pump compatible with the Zoeller Qwik Jon unit. After completing the installation, we tested the system to verify proper pump operation, drainage, and leak free performance. The system is now functioning as intended.

We responded to our customer in Alpharetta, GA after they reported a clogged toilet in the powder room that would not flush properly. Upon inspection, we found a blockage in the toilet drain preventing waste and water from flowing through as intended. We used a hand auger to break up and remove the obstruction without having to remove the toilet. Once the blockage was cleared, we flushed the toilet multiple times and monitored the drainage to ensure the line was flowing properly. The toilet is now flushing normally, draining correctly, and no further issues were found during testing.

We responded to our customer in Alpharetta, GA after they noticed signs of a water leak but were unsure of the source. We ran the bathtub, shower, and flushed the toilet multiple times but found no active leaks. We then filled the bathtub and drained it while monitoring below and still found no signs of water leaking from the tub or drain system. After further investigation, we discovered a crack in the toilet bowl that was allowing water to escape. We initially rebuilt the toilet before identifying the crack in the porcelain. We then replaced the toilet with a new Kohler Cimarron and tested for proper flushing and leak free operation.

We responded to our customer in Alpharetta, GA to complete a kitchen and laundry plumbing remodel. We relocated the kitchen plumbing approximately 3 feet to accommodate the new layout and installed a new ice maker box for the refrigerator water line. We also extended the plumbing for a laundry sink to provide proper water and drain connections. After completing the work, we tested all plumbing connections for proper operation and leak free performance.

We responded to our customer in Alpharetta, GA to address a failing sewage ejector pump. We removed the existing unit and installed a new Liberty sewage pump to restore proper wastewater removal. All connections were properly secured during installation. Once the installation was completed, we tested the system for proper operation and leak free performance.

We responded to our customer in Alpharetta, GA to address leaking or failing shut off valves under the bathroom sink. We removed the old valves and installed new shut off valves and supply lines for the lavatory faucet. All connections were properly secured during installation. Once the replacement was completed, we ran water and tested for proper, leak free operation. The lavatory plumbing is now functioning correctly.

We responded to our customer in Alpharetta, GA after they reported a leak in the sprinkler line under the turf. Upon inspection, we located a pinhole leak in an elbow fitting beneath the astro turf. We cut out the damaged section and replaced the faulty elbow to restore proper flow. After completing the repair, we turned the system back on and tested for leak free operation.

We responded to our customer in Alpharetta, GA after they reported a toilet constantly running. Upon inspection, we found the home’s water pressure was at 110 PSI, which is above the recommended level of 80 PSI and can cause plumbing issues. We replaced the pressure reducing valve (PRV) to bring the pressure back to a safe range. We also rebuilt the toilet to stop the continuous running. After completing the work, we tested the system for proper operation and leak free performance.

We responded to our customer in Alpharetta, GA after they reported a toilet clog and flushing issue. Upon inspection, we found a toy lodged inside the toilet, blocking the waste flow. We removed the obstruction to restore proper drainage. After clearing the blockage, we flushed the toilet multiple times to confirm normal operation. The toilet is now functioning properly.

We responded to our customer in Alpharetta, GA to install a new Rheem 50 gallon gas water heater in the basement utility room. We removed the existing unit and installed the new water heater, ensuring all gas, water, and vent connections were properly secured. While on site, we also performed a tankless water heater descale and maintenance service to improve efficiency and extend the life of the unit. After completing the work, we tested both systems for proper operation and leak free performance. Everything is now functioning correctly and providing reliable hot water.

We responded to our customer in Alpharetta, GA to inspect a sewage ejector pump running continuously. Upon evaluation, we found the float was not installed properly, causing the pump to cycle nonstop. Improper float positioning can lead to premature pump wear and potential failure. We discussed the issue with the customer and recommended correcting the float installation to restore normal operation.

Arrived to perform a site visit to install a new Rheem Marathon water heater. Evaluated site and went over different options with customer. Customer is going to furnish the Rheem Marathon water heater and at that time we will return to install the new water heater as well as flush the Rheem tankless water heater.

We responded to our customers non profit organization to continue work on their ongoing bathroom remodel. Today, we installed a new Kohler Cimarron Toilet, shower trim with diverter, and a lavatory faucet along with the necessary water supply and drain connections. These upgrades were needed to complete the bathroom remodel and ensure the bathroom is fully functional for daily use. All fixtures were properly set, sealed, and secured. The water and drain lines were connected to ensure proper flow and drainage. Once the installation was completed, we ran water through all fixtures and inspected every connection. Everything is now functioning as intended and is leak free.

We responded to our customers home to service their tankless water heater after it began displaying error code 10. Upon inspection, we determined the issue was caused by debris buildup inside the burner assembly, which was restricting proper combustion. We shut down the unit and cleaned the burner assembly to remove the debris and restore proper airflow. After completing the cleaning, we reassembled the unit and returned it to service. We monitored the system during operation to ensure proper ignition and stable performance. The error code cleared and the tankless water heater resumed normal operation. The unit is now heating water efficiently and functioning as designed.

We responded to our customer due to their master bathroom remodel and need for professional rough in plumbing services. Upon arrival, we completed the rough in phase, including installing new water supply lines, drain lines, waste and vent piping to meet current plumbing code. We measured and set pipe locations for the shower, toilet, and vanity to ensure proper fixture placement. All connections were securely glued, strapped, and pressure tested to verify leak free operation. We also installed stub outs and capped lines in preparation for the finish plumbing stage. The system was inspected for proper slope, alignment and ventilation to ensure long term reliability. This completed the rough plumbing portion and prepared the bathroom for drywall and tile installation.

We were called out to inspect a water leak at the meter and found the issue was coming from a damaged copper water line connected to the service. Upon arrival, after exposing the area, we located the compromised section of copper piping that was allowing water to escape. We cut out the damaged portion and installed a new section of copper pipe, securing all the fittings and connections to ensure a long lasting repair. Once the repair was complete, we restored water pressure and tested the line for leaks at the meter and along the nearby service line.

We responded to our customer due to water pooling near the playground area, indicating a possible underground leak. Upon arrival, to locate the source, we moved back the turf and dug down to expose the plumbing beneath. Once the area was opened, we discovered that the irrigation system was leaking from a damaged black rubber supply tube. Since irrigation systems require specialized components and adjustments, we recommended an irrigation company complete the repair to ensure long term reliability. To stop the active leak and prevent further water loss or ground saturation, we turned off the irrigation system. After securing the area, we backfilled the hole and restored the turf to its original position. Also during our visit, we found the meter box completely full of water. We pumped out the standing water and turned the water back on to locate the source of the leak. After testing, we determined there was an active water leak on the copper line just after the water meter.

We responded to our customers home to complete a full plumbing rough in as part of their bathroom remodel, which required relocating several fixtures to fit the new layout. Once on site, we began by removing the existing lavatory and rerouting the drain and supply lines approximately two feet to match the new vanity location. We then relocate the shower drain and repositioned the P-trap so it would properly line up with the new shower base. The toilet rough in also needed to be shifted about six feet to accommodate the redesigned floor plan, so we installed the closet bend piping and secured the new flange location. All drain, waste, and vent connection were fitted, glued, and checked for proper alignment. Once the rough in adjustments were complete, we pressurized the supply lines and ran water through the drains to verify leak free operation.

We responded to our customer to install a customer supplied 8" lavatory faucet with a pop up drain assembly. The existing faucet was outdated and beginning to show signs of wear, so our customer chose to upgrade to a newer model. Once on site, we removed the old faucet and drain assembly, cleaned the sink surface and installed the new faucet and pop up assembly according to manufacturer specifications. All water supply lines and connections were tightened and properly sealed. Once the installation was complete, we restored water pressure and tested the faucet and drain for leak free operation.

We responded to our customers home to replace both shut off valves at a pedestal sink located in the powder room. Once on site, we inspected the existing angle stop valves and found they were worn and no longer sealing properly, which can lead to leaks or failure when shutting off water. We shut down the water supply to the fixture and removed the old, deteriorated shut off valves. New, high quality shut off valves were installed to provide dependable water control to the sink. After completing the installation, we restored water to the fixture and checked all supply line connections. We thoroughly tested the new valves for proper operation and verified everything was leak free.

We responded to our customer after they reported that their shower was not draining properly and the water supply wasn't functioning. Once on site, we inspected the shower and found a significant blockage in the drain line that was preventing water from flowing out. We also discovered that the existing supply lines were failing to deliver water to the fixture. We cleared the clog from the drain to restore proper drainage. After that, we replaced the faulty supply lines with new, reliable lines designed for consistent water flow. Once the installation was complete, we restored water to the system and thoroughly tested the shower.

Our customer had contacted us to clear a toilet stoppage at one of his schools. He had tried using a toilet auger to clear the toilet stoppage thinking it was just a toy or some small object that was blocking the toilet. Once on site we removed the toilet and ran the auger through the toilet but the blockage was not in the toilet but was in the line, we then performed a drain cleaning by running the large sewer machine through the toilet drain line. We cleared soft blockage and reset toilet to resolve stoppage issue. We pulled the toilet to run the drain machine down, then reset the toilet and tested for proper leak free operation.